Breadboard Power Module 830 points Solderless Prototype Bread board kit Jumper wires Cables For Arduino diy kit Raspberry Pi

Breadboard Power Module 830 points Solderless Prototype Bread board kit Jumper wires Cables For Arduino diy kit Raspberry Pi

Breadboard :

• Ideal for high frequency and low noise circuits
• Interconnect any components with 20-29 AWG(0.3-0.8 mm) wire
• 830 points
• Size: 16.5 x 5.5 cm

Breadboard Power Module :

• Breadboard power supply module, compatible with 5 V, 3.3 V
• Apply to MB102 breadboar
• Input voltage: 6.5-12 V (DC) or USB power supply
• Output voltage: 3.3V/5V can switch over
• Maximum output current: <700 ma
• Fluctuation two road independent control, can switch over to 0 V, 3.3 V, 5 V
• On-board two groups of 3.3V, 5V DC output plug pin, convenient external lead use.
• Size:5.3cm x 3.5cm

Jumper wires Cables :

• 65pcs Multi coloured Solderless Flexible Breadboard Jumper Cable Wires 4 different lengths M/M for Arduino, Raspberry Pi Model A / Model B 1 1+ 2 3 / Zero/ Computer Module
• A variety pack of 65pcs multicoloured male to male 0.1" jumpers in different lengths, includes 10cm/3.9inch, 15cm/5.9inch, 20cm/7.8inch, 25cm/9.8inch.
• The plastic ends of these cables are round and slightly smaller, and the metal jumpers are softer. This means that you can plug a jumper into a breadboard slot or header, bend it over to the side and then add another.
• Please note that bending the end of the jumper will cause Metal Fatigue and it will wear out more quickly.