ESP-01 ESP-01S ESP8266 RGB LED Controller Adpater WIFI Module for Arduino IDE 16 Bits Light Ring Christmas DIY WS2812 WS2812B
QUESTIONS & ANSWERS
Have a Question?
Be the first to ask a question about this.
Share this Product
This is a WS2812 RGB LED control module based on ESP-01 / 01S. With it, you can easily control the WS2812 light bar / light ring. DIY own lighting control system. Support for Ard uino IDE programming.
* Master: ESP-01 / ESP-01S (This module include ESP-01 / ESP-01S)
* Control Pin: GPIO2
* Interface: 3Pin PH2.0 connector
* Operating Voltage: DC 3.7V-5V (Please note: The positive supply voltage VCC on the board is connected to the VCC on the WS2812 3PIN connector. Therefore, if your light bar / lamp ring is 5V powered, use DC 3.7V-5V power supply.)
* Support 3.7V lithium battery
1.ESP-01S/ESP-01 RGB LED module X1 (include ESP-01S/ESP-01 WiFi module and RGB LED)
2. 3PIN PH2.0 connector X1
3.RGB LED Ring 16 Bit WS2812 5050 RGB LED with Integrated Driver
Note:It dose not include battery
1. Power supply: 3.7V-5V DC power supply to the VCC GND (2.54mm pin)
2.Download the program to ESP-01S
3. Insert the ESP-01 / ESP-01S into the 2 * 4 Pin header (in the direction of the arrow) as shown below: